If the lamp uses LED lamps with strong ultraviolet emission, or white and blue LED lamps, it may attract more insects, especially at night or in summer. On the contrary, if the lamp uses red light or warm white light, such lamps will be less attractive and the probability of insects gathering is relatively low.

Generally speaking, the length of the vanity wall light is recommended to be no more than 1/3 of the dressing table. Specifically, for a 72-inch dressing table, a wall light with a length between 24 and 36 inches (about 61 to 91 cm) can be selected.

For example, if you need to provide uniform lighting for a 20 square meter area and the target illumination is 300 lumens/square meter, the total lumens required is: Total lumens = target illumination × space area = 300 × 20 = 6000 lumens Then, calculate the required wattage based on the luminous efficacy of the selected LED lamp. For example, assuming that the selected luminous efficacy is 150lm/W, the required wattage is: Required wattage = 6000/150 = 40W

long dining tables, corridors, large conference rooms and halls may appear unevenly lit or too bright in some areas if traditional round chandeliers are chosen, while linear LED chandeliers can provide more uniform lighting effects, ensuring a more balanced lighting effect for the entire space.

Color temperature is a physical quantity that describes the color of a light source, usually in Kelvin (K). The color temperature represents the degree of warmth or coolness of the color tone of the light source. Color temperature is defined by simulating blackbody radiation.

For track lights, the bulb is one of the key factors that determine its lighting effect. With the popularization of LED technology, more and more track lights have begun to use LED bulbs as light sources because LED bulbs have the advantages of high energy efficiency, long life, low heat, and environmental protection.

Aluminum alloy is a very suitable material for outdoor lighting fixtures, especially outdoor wall lamps. Its advantages include: ● Corrosion resistance ● Weather resistance ● Lightness ● Machinability Ordinary iron is often not recommended for outdoor lighting for the following reasons: ● Corrosion resistance ● Insufficient strength

Pros of LED recessed downlights: 1. Energy-saving and high efficiency 2. Modern and simple appearance design 3. Uniform light effect and reduced glare 4. Flexible installation methods 5. Adapt to a variety of scenarios and needs Cons of LED recessed downlights: 1. High installation requirements 2. Inconvenient maintenance 3. Restrictions on light adjustment 4. High cost

Although the LED chip itself requires direct current to work properly, most home and commercial power systems provide alternating current. Therefore, when the LED lighting downlight is working, it needs to convert the alternating current into direct current through a power driver module.

LED itself is a point light source with strong divergence of light. In LED spotlights, through reasonable optical design and the role of lens or reflector, the propagation direction of light can be changed and the divergence of light can be reduced, thereby focusing the light beam to a specific area.

LED track light has a wider beam. Although it can adjust the direction and angle of illumination, its beam concentration is lower than that of spotlights. It is mainly used to provide uniform lighting effects and is suitable for large areas. lighting needs.

● SMT: SMT is an electronic component assembly technology that describes the process of directly mounting electronic components (including SMD components) on the surface of a circuit board. ● SMD: SMD refers to surface mount diodes, which is a packaging method for LEDs. It describes the physical packaging form of LED components and is the basis for implementing the SMT process.