✅ Adjust the sensing range: If the night light supports adjustment, reduce the sensing distance and angle. ✅ Optimize the installation location: Keep away from interference factors such as heat sources, air vents, windows, etc. ✅ Physical shielding: Use stickers or light shielding sheets to reduce the sensor's sensing range. ✅ Switch to low sensitivity mode: If the night light supports this function, the probability of false triggering can be reduced.

● Physical method: cover the sensor, adjust the installation position, or disconnect the sensor circuit. ● Electronic method: use manual mode, adjust the sensitivity, or turn off the motion detection function in the smart APP.

✅ Yes, but you need to choose the right tape, ensure sufficient adhesion, and avoid covering the sensor and heat dissipation parts. ❌ It is not recommended to use ordinary tape or cover key components, otherwise it may affect the sensing function, heat dissipation effect, and even shorten the life of the lamp.

The production steps are summarized as follows: ● Design the circuit schematic to ensure that all components are connected correctly. ● Build the circuit and test it, and use a breadboard for preliminary testing. ● Install LED lights and sensors to ensure the best sensing range. ● Make the shell to improve the aesthetics and durability. ● Debug and optimize, adjust the sensitivity, add photosensors, and improve energy saving.

✅ LED light source quality: high brightness, color rendering index Ra>80, no flicker, low light decay ✅ Sensor performance: high sensitivity, fast response, strong anti-interference ability ✅ Power drive: stable voltage, high power factor, over-current and over-voltage protection ✅ Heat dissipation design: aluminum alloy radiator, low temperature rise ✅ Shell material and protection: sturdy and durable, high waterproof grade

If it is battery-powered, try to replace the new battery and make sure the positive and negative poles of the battery are installed correctly. If it is a rechargeable lamp, try to charge it for 2-3 hours and test it again to check whether the charging port is loose.

● Check the power socket or switch: If it is a plug-in infrared induction led light, try to change the socket or use a multimeter to test whether the socket is powered normally. ● Check the wire contact: For LED lights powered by DC (such as battery power), check whether the battery is exhausted or whether the contact is poor.

The working hours of LED human body induction lights are not limited to nighttime. Their working mode is closely related to the type of sensor used. LED human body induction lights with light sensors mainly rely on changes in ambient light. They usually work when the light is dark and automatically turn off when the light is strong.

it can be seen that not every room needs to install wireless motion sensor led light. For spaces with frequent activities and stable light requirements, such as living rooms and kitchens, traditional lighting systems are sufficient to meet the needs.

If there are elderly, children or family members with limited mobility in the family, the led motion sensor light can provide safety protection at night. In a dark environment, the automatically lit light can effectively reduce the risk of falling and ensure the safety of family members.

Automatic sensor night lamp is an intelligent lighting device that can automatically light up or turn off according to environmental conditions. Unlike traditional night lights, it does not require manual switches, but relies on built-in sensors to automatically detect light, human body or other physical changes to intelligently control the on and off of lights.

Possible reasons for indoor led sensor light flickering: 1. Unstable power supply voltage 2. Sensor failure or interference 3. Lamp quality problems 4. Installation environment problems 5. Lamp aging